Engineering Centre

Hi, can you advise what the installation Torque is for a HUS4-H M12 anchor (with 60mm nominal embedment). The values for an M12 don't appear to be in the various lierature

new suspended floor construction in existing building: I want to bolt a bearer to the wall and then fix the floor joists on hangers. What resin anchors should I use to bolt the bearer to the wall and how do I test them?

Been asked to use slotted holes with slots in direction of max shear. Client wants to use HILTI filling set. What is the max allowable clearance allowed that filling set will work to based on resin anchor diameter thru S275 baseplates.

Jag önskar hjälp med lösning av infästning av väggsväggsskena i en HSQ balk. Baken är inklädd i brandisolering FPS 17 40mm (EI60)

I am looking to cost up a fixing detail to hold an L-Shape Galvanised Lintel to a reinforced concrete structure, it is to provide a ledge detail to allow a propriatry system to be stacked on, the lintel will measure 100mm x 200mm and be 2.9m in length, the approx loading will be circa 500kg per lintel which fixings would you r...

the below is the extract from the structural engineers report ‘The new foundation 450 wide x 200 thick GEN1 mass concrete) shall be chemical anchor dowel tied to the existing foundation with 4Nr H20 Hilti chemical anchor dowel bars 600mm long (300 embedment)’ please can you confirm what products are required for this

Good morning, Is there any way to design resin anchors in 100mm thick 7N/mm2 blockwork using the PROFIS software? Or by other means? Regards, Joel

Hi, I am looking for a Hilti software for designing and modelling Hilti MT systems. Kindly provide input. Thanks

I'm looking to specify an injectable mortar/resin for a through bolt connection, because it's a non-standard application the test data within the product datasheets isn't applicable and we are providing additional fire protection on the outside of the connection to limit maximum temperatures during a fire. Most of the resins ...

I am looking to specify a HAS-U 8.8 rod fixed with HIT-RE500V4 into concrete. It is intended that the rod will extend out of the concrete and be welded to a steel plate, after it is fixed into the concrete. The rod is going to become extremely hot during welding - will this impact the performance of the resin? Thanks for your ...