Engineering Centre

Hej! Jag har beräknat infästning med armering från ny till befintlig betongkonstruktion i profis. I programmet går det att beräkna med Hilti-hit hy 200-R V3, men inte Hilti-hit hy 200-A. Befintlig betong är satt som sprucken och beräkningen ger resultat utan problem. Men i produktbeskrivningen för R V3 står det endast att de...

Hello, is Hilti HIT-FP 700-R available in Profis Engineering*? If not, what product resembles it the closest in Profis*? https://www.hilti.se/c/CLS_FASTENER_7135/CLS_CHEMICAL_ANCHORS_7135/r13812960 *Edit: Anchoring-to-concrete module of Profis

Hej! Vi ska injektera i våt betong angripen av ASR och med en del befintliga sprickor. Vi vattenbilar bort dålig betong i ytan samt injekterar / lagar befintliga sprickor > 0.3 mm. Vilken av era produkter bör man välja för maximal vidhäftning till befintlig betong?

where i could find them for the recent veiwed webinars?

Did the Hilti-HY-200A replace the HY-150? I am looking to run design checks on existing brackets with HY-150 MAX resin that has been used. Can I simply model the existing conditon with the HY-200a?

Hi, How close can I drill and install a resin anchor next to an existing one that now will be dedudant? Is there a rule?

Will hilti Re500 v4 cartridges fit into a hilt HDM 330 gun/applicator

Can i use Hilti PS 1000 x-scan data to produce a report similar to ferroscan document with just rebar cover levels

I am currently designing a connection between a 914x20 CHS pier post and a concrete base. This is required to transfer a relatively high moment of 2,300kNm. This causes failure in concrete breakout due to the tension applied to the anchors when considered without supplementary reinforcement. The anchors were originally propo...

What is the best way to check Anchors in a composite slab UK? The total depth of the Slab is 190mm but at its most shallow depth it is 130mm. The anchors will not work in a 130mm slab. What is the best way to design the baseplate and Anchors in a composite slab UK?