Engineering Centre

I have several load combinations that I would like to check for seismic design, for a design that I have in Hilti Profis. The Import load combinations feature is very useful however whenever I paste my load combinations in here they default to Static design so I need to click each row manually to change it to Seismic design. ...

Fixing end of beam to sloping column head Vertical load 92kN Ultimate value, with eccentricity of load say 200mm then this generates a moment of about 20kNm Concrete C25/30. What would be the best solution for this if fixing through the end plate only and which type of fixings. Is it also possible to speak to one of the tech...

Please explain why the resulting tension is located at the corner of the plate. I expect it is located at the center of the plate.

Hello, I edited an existing document by changing just the loads on a connection and now it does not give me the utilization and some other information that it used to give me in the past.

We have a query where a contractor wants to cut down the projection of resin anchors in a column baseplate. They are asking what the minimum projection of bolt above the nut should be. I had it in my head as 2 full threads but I think it is for connections. Can you please advise what the minimum number of threads above the nu...

Hi, As shown in the attached picture, I want to design an end anchorage connection of the new beam to the existing beam (support). Can I choose the Beam to Column that is the same as that? Is it possible to create a new steel diameter? Thank in advance

Hi, I get the following error message: Advanced baseplate calculation is not possible when using baseplate stand-off. when I switch my design from Stand-off with grouting to clamping

I am using Hilti Profis for assessment a Dam beam guard rail. I want to distribute shear force in all anchor bolts, so I have opted 'Fill Holes' option. I am not sure either the filling morter will work under water or not.

Hello, Is it possible to make the load eccentric on the L-beam? Right now, I can only get the load to hit the center of the steel.

I have a hole smaller than 25mm in a plasterboard wall, it has a 20mm steel conduit going through the hole. Can I use the putty disc for this application?